For my first bake of the new year, I was asked to make a special two-tiered 50th Birthday cake. My initial thought was eeeek! having not stacked anything before, but as I began to read up about the process and started to plan everything out, it all became much clearer.
The brief was for a two-tiered fruit or carrot cake with flowers and a No. 50 to fit in with a pink, black (but not too much) and silver cocktail themed party. I sketched out the design, and then sent it over to the client who was very happy with the design.
After baking a delicious carrot cake recipe with rum-soaked raisins, walnuts, coconut and a sharp citrus drizzle, I double iced both cakes and marked out my design using cocktail sticks. I drew out the arrangement of the stripes and position of the top cake using greaseproof paper. In the picture below you can see the cocktail sticks marking where the dowelling would be placed, and the rest of the details.
Top Tip: When marking out your design through the greaseproof paper, lightly score it onto the icing instead of poking it through with a point. If you make a mistake, a light line is easier to erase than a point.
I used plastic dowelling rods for the cake and made sure that I cut them a couple of millimetres shorter than the top of the icing. If they stand too far up the top cake will wobble on the rods and make the cake look unsteady. If they are bit shorter, the top cake will sit snugly and safely on top when stuck on with royal icing.
I marked out the arrangement of my stripes beforehand on greaseproof paper, but when I had finished the bottom tier and started on the top tier (you know where i'm going with this...) they didn't match up! If I had stuck to my original plan, some of the top stripes would have overlapped the bottom ones, and wouldn't have sat properly in between the gaps.
When I do this technique again, I will only mark out the bottom tier, and then a circle on the top tier to show where the stripes should stop. With this method, all I will need to do is to to measure the length and width of the stripe (not the position) and work by eye to make sure that they sit symmetrically in the gaps between the stripes on the bottom tier.
After finishing the stripes, I wrapped ivory ribbon around the cake board, bottom and top tiers, and then piped a circle of sugar pearls around the top of each set of stripes. I think this finished the cake off very nicely and gave another decorative element to the cake.
My client had specified that she wanted a No. 50 on top of her cake so I decided to use the candycane method. The numbers turned out really well and the curly design contrasted well with the straight stripes.
Top Tip: Do not try to use old icing when doing this, it is very difficult to make the two colours to stick together if you do. Whilst making one figure, keep the icing for the other wrapped in clingfilm to stop it drying out.
I was very pleased with the white open roses I made for the cake. I used slightly larger flower cutters than for the flowers I made for my nan's cake and used three layers, all in different sizes. When they were dry, I dusted them with an edible silver lustre and piped the centres using black royal icing. The flowers finished the cake off perfectly and shone silver when under a spotlight, perfect for a party!
To clean the icing sugar off the stripes for the cake and to gloss the numbers, I used a paintbrush and a little water to go over the pink parts. Not only did this clean everything, but it gave a wonderfully glossy finish and a professional edge to the finished cake.
No comments:
Post a Comment